Indoor Led Downlights Anti-glare Ceiling Fixtures Suppliers

Install indoor led downlights

1. Technological process of indoor led downlights : installation of lamp holder and lamps → connecting and leading off the line → lamp test

2. Installation of indoor led downlights holder and lamps: 1) Measure the installation height of the lamp holder according to the design requirements, and draw a mark on the pole. 2) Put the lamp holder and lamps on the pole (for heavier lamp holder and lamps, pulleys can be used, and the pole can be hung on the big rope), wear the hoop or bolt, and find the illumination Angle and flatness according to the design requirements.

3. Lead off: fix the pin insulator on the lamp holder, tie one end of the wire to the insulator and connect it with the lamp holder line and fuse separately. The rubber cloth and the black tape overlap each other and wrap one layer. Then, the other end of the wire is tensioned and connected with the street lamp trunk after the back buckle.

4. The phase line of the indoor led downlights shall be equipped with a fuse, and the phase line shall be connected to the central terminal of the screw cap.

5. The connection point between the line and the main street lamp should be 400~600mm away from the center of the pole, and be symmetrical on both sides.